Savana 1500 RWD V6-4.3L (2007)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Pre-Charge Pump Replacement
Brake Pressure Modulator Valve Pre-Charge Pump Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice.
1. Disconnect the negative battery cable.
2. Remove the left front wheel and tire.
3. Remove the inner fender splash shield.
4. Disconnect the pre-charge pump (PCP) motor.
5. Remove the PCP electrical connector from the PCP bracket.
6. Remove the engine harness from the PCP bracket.
7. Remove the engine harness retainer from the inner fender above the PCP.
8. Remove the connector C100, above the engine harness, from the inner fender.
9. Move the connector C100 and the engine harness up, away from the PCP.
10. Loosen and remove the brake fluid outlet pipe (5). Cap or plug the brake pipe to prevent contamination and brake fluid loss.
