Savana 1500 RWD V6-4.3L (2007)
Notice: Refer to Fastener Notice.
3. Install the balance shaft retainer and bolts.
Tighten the bolts to 12 N.m (106 lb in).
4. Install the balance shaft driven gear onto the balance shaft.
5. If reusing the fastener, apply threadlock to the threads of the balance shaft driven gear bolt. Refer to Sealers, Adhesives, and Lubricants for the
correct part number.
6. Install the balance shaft driven gear bolt.
1. Use a wrench to secure the balance shaft.
Place the wrench onto the balance shaft near to the balance shaft front bearing.
2. Install the balance shaft driven gear bolt.
1. Tighten the balance shaft driven gear bolt on the first pass to 20 N.m (15 lb ft).
2. Tighten the balance shaft driven gear bolt on the final pass using the J 45059 an additional 35 degrees.
7. Remove the wrench from the balance shaft.
8. Rotate the balance shaft by hand in order to ensure that there is clearance between the balance shaft and the valve lifter pushrod guide. If the
balance shaft does not rotate freely, check to ensure that the retaining ring on the balance shaft front bearing is seated on the case.
9. Install the balance shaft drive gear. DO NOT install the camshaft sprocket bolts at this time.
