Savana 1500 RWD V6-4.3L (2007)
6. Use the J 23523-F in order to press the crankshaft balancer onto the crankshaft.
Notice: Refer to Fastener Notice.
1. Install the J 23523-F plate and bolts onto the front of the crankshaft balancer.
Tighten the plate bolts to 25 N.m (18 lb ft).
2. Install the J 23523-F screw into the end for the crankshaft.
3. Install the J 23523-F bearing, the washer, and the nut onto the screw.
4. Rotate the J 23523-F nut clockwise until the crankshaft balancer hub is completely seated against the crankshaft position sensor reluctor ring.
7. Remove the J 23523-F.
8. Install the crankshaft pulley and bolts.
Tighten the crankshaft pulley bolts to 58 N.m (43 lb ft).
9. Ensure that the crown of the crankshaft balancer washer (2) is faced away from the engine.
