Savana 1500 RWD V6-4.3L (2007)
inserted into the connector, check by giving tube a forceful pull.
1. Install the oil cooler hose assembly and a new gasket.
Notice: Refer to Fastener Notice.
2. Install the oil cooler hose adapter bolts (2).
Tighten the bolts to 12 N.m (106 lb in).
3. Install the oil cooler hose bracket bolt (1).
Tighten the bolt to 25 N.m (18 lb ft).
4. Install the oil cooler hoses to the hose clip on the fan shroud.
5. Snap the oil cooler hose clip shut.
Important:
^
Ensure the oil cooler line being installed has a plastic cap on the end that connects to the quick connect fitting. If no plastic cap
exists, or the plastic cap is damaged, obtain a new cap. Install the cap on to the cooler line prior to cooler line installation.
^
Do not use the plastic cap in order to install the cooler line into the fitting.
Connect the oil cooler lines.
7. Pull back sharply on the cooler line in order to ensure that the cooler line is installed in the quick connect fitting.
