Savana 1500 RWD V6-4.3L (2007)
1. Apply a 4.0 mm (0.157 in) patch of adhesive to the cylinder head side of the lower intake manifold gasket at each end. Refer to Sealers,
Adhesives, and Lubricants for the correct part number.
Important: The lower intake manifold gasket must be installed while the adhesive is still wet to the touch.
2. Install the lower intake manifold gasket onto the cylinder head.
Use the gasket locator pins in order to properly seat the lower intake manifold gasket on the cylinder head.
Important: The lower intake manifold must be installed and the fasteners tightened while the adhesive is still wet to the touch.
3. Apply a 5 mm (0.197 in) bead of adhesive to the front top of the engine block. Refer to Sealers, Adhesives, and Lubricants for the correct part
number.
4. Extend the adhesive bead 13 mm (0.50 in) onto each lower intake manifold gasket.
5. Apply a 5 mm (0.197 in) bead of adhesive to the rear top of the engine block. Refer to Sealers, Adhesives, and Lubricants for the correct part
number.
6. Extend the adhesive bead 13 mm (0.50 in) onto each lower intake manifold gasket.
7. Install the lower intake manifold onto the engine block.
8. If reusing the fasteners, apply threadlock to the threads of the lower intake manifold bolts. Refer to Sealers, Adhesives, and Lubricants for the
correct part number.
9. Install the lower intake manifold bolts.
