Savana 1500 RWD V6-4.3L (2007)
4. Identify the correct rotor mounting position:
*
At the rotor screw holes (1)
*
At the rotor locator pin holes (2)
5. Install the distributor rotor according to the index marks.
6. Install two rotor hold down screws.
Tighten the screws to 1.9 N.m (17 lb in).
7. Install the shim washer (1) on the bottom of the distributor shaft.
8. Install the tang washer.
9. Install the round washer.
10. Install the driven gear according to the index marks.
11. Align the rotor segment as shown for a V6 engine (1) or V8 engine (2).
12. Install the gear and align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
13. Check to see If the driven gear is installed incorrectly, the dimple will be approximately 180 degrees opposite the rotor segment when it is
installed in the distributor.
