Savana 1500 RWD V6-4.3L (2007)
6. As the distributor is being installed, observe the rotor moving in a clockwise direction about 42 degrees.
7. Once the distributor is completely seated, the rotor segment should be aligned with the mark on the distributor base (1).
*
If the rotor segment is not aligned with the mark, the driven gear teeth and the camshaft have meshed one or more teeth out of alignment.
*
In order to correct this condition, remove and reinstall the distributor.
Notice: Refer to Fastener Notice.
8. Install the distributor mounting clamp bolt.
Tighten the bolt to 25 N.m (18 lb ft).
9. Install the distributor cap.
10. Install the new distributor cap screws.
Tighten the screws to 2.4 N.m (21 lb in).
11. Install the electrical connector to the distributor.
12. Install the spark plug wires to the distributor cap.