Savana 1500 RWD V6-4.3L (2007)
Blower Motor Resistor: Service and Repair
Auxiliary Blower Motor Resistor Assembly Replacement
Auxiliary Blower Motor Resistor Assembly Replacement
Removal Procedure
1. Remove the left rear quarter trim panels.
2. Disconnect the electrical connector from the blower motor resistor.
3. Remove the retaining screws.
4. Remove the blower motor resistor from the blower case.
Installation Procedure
1. Install the blower motor resistor into the blower case.
Notice: Refer to Fastener Notice.
2. Install the retaining screws to the blower case.
Tighten the screws to 2 N.m (18 lb in).
3. Connect the electrical connector to the blower motor resistor.
4. Install the left rear quarter trim panels.
