Savana 1500 RWD V6-4.3L (2007)
Turn Signal Switch: Service and Repair
Park/Turn Signal Lamp Replacement (Base Vehicles)
PARK/TURN SIGNAL LAMP REPLACEMENT (BASE VEHICLES)
REMOVAL PROCEDURE
1. Remove the screws (3) from the park/turn signal lamp to the grille.
2. Remove the park/turn signal lamp (2) from the grille.
3. Disconnect the bulb socket (1) from the park/turn signal lamp by turning the bulb sockets in a counterclockwise direction.
4. Remove the bulb (1) from the socket.
INSTALLATION PROCEDURE
1. Install the bulb (1) into the socket by turning the bulb sockets in a clockwise direction.
2. Connect the bulb socket (1) into the park/turn signal lamp.
3. Install the park/turn signal lamp (2) to the grille (5).
4. NOTE: Refer to Fastener Notice.
Install the park/turn signal lamp retaining screws (3) to the grille.
Tighten the screws to 1.5 N.m (13 lb in).
