Savana 1500 RWD V6-4.3L (2007)
Turn Signal Flasher: Service and Repair
HAZARD AND TURN SIGNAL FLASHER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left knee bolster bracket.
2. Remove the turn/hazard flasher (2) from the instrument panel (I/P) support.
3. Disconnect the electrical connector (1).
4. Remove the turn/hazard flasher (2).
INSTALLATION PROCEDURE
1. Connect the electrical connector (1) to the turn/hazard flasher (2).
2. Install the turn/hazard flasher (2) to the instrument panel (I/P) support.
3. Install the left knee bolster bracket.
