Savana 1500 RWD V6-4.3L (2007)
Air Cleaner Fresh Air Duct/Hose: Service and Repair
Air Cleaner Outlet Resonator Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Remove the retaining nut (1) from the air cleaner outlet.
4. Remove the air cleaner outlet duct (2) from the throttle body assembly.
5. Disconnect the harness connector of the intake air temperature (IAT) sensor.
6. Loosen the air cleaner outlet duct from the mass air flow (MAF) sensor.
7. Remove the air cleaner outlet duct.
Installation Procedure
Notice:
*
Handle the MAF sensor carefully.
*
Do not drop the MAF sensor in order to prevent damage to the MAF sensor.
*
Do not damage the screen located on the air inlet end of the MAF.
*
Do not touch the sensing elements.
*
Do not allow solvents and lubricants to come in contact with the sensing elements.
*
Use a small amount of a soap based solution in order to aid in the installation.
Install the air cleaner outlet duct to the MAF sensor.
*
Connect the IAT sensor harness connector.
*
Install the air cleaner outlet duct (2) on the throttle body assembly.
Notice: Refer to Fastener Notice.
*
Tighten the retaining nut (1).
Tighten the nut 2 N.m (18 lb in).
*
Install the engine cover.
*
Connect the negative battery cable.
