Savana 1500 RWD V6-4.3L (2007)
6. Line up the square-cut hole in the vane wheel with the camshaft position (CMP) sensor.
7. Remove the two screws that hold the camshaft position (CMP) sensor.
8. Discard the screws.
9. Remove the CMP sensor.
10. Note the dimple located below the roll pin hole on one side of the gear. The dimple will be used to properly orient the gear onto the shaft during
reassembly.
Caution: Refer to Safety Glasses Caution.
11. Support the distributor drive gear in a V-block or similar fixture.
12. Drive out the roll pin with a suitable punch.
13. Remove the driven gear from the distributor shaft.
