Savana 1500 RWD V6-4.3L (2007)
14. Remove the round washer.
15. Remove the tang washer.
16. Remove the shim washer (1).
17. Remove the old oil seal.
Assembly Procedure
Important: Installing the driven gear 180 degrees out of alignment, or locating the rotor in the wrong holes, will cause a no-start
condition. Premature engine wear or damage may result.
1. Line up the square-cut hole in the vane wheel for the camshaft position (CMP) sensor.
2. Insert the sensor into the housing.
Notice: Refer to Fastener Notice.
3. Install two new screws for the camshaft position (CMP) sensor.
Tighten the screws to 2.2 N.m (20 lb in).