Savana 1500 RWD V6-4.3L (2007)
13. Install the ignition coil wire. Note the correct orientation of the wire boot.
Important: If the malfunction indicator lamp illuminates after installing the distributor and DTC P1345 is set, the distributor has been
installed incorrectly.
14. Refer to Installation Procedure 2 if the malfunction indicator lamp illuminates after installing the distributor.
15. Install the engine cover.
Installation Procedure 2
Important: Rotate the number 1 cylinder to top dead center (TDC) of the compression stroke. The engine front cover has 2 alignment
tabs and the crankshaft balancer has 2 alignment marks spaced 90 degrees apart which are used for positioning the number 1 piston at
TDC. With the piston on the compression stroke and at TDC, the crankshaft balancer alignment mark (1) must align with the engine
front cover tab (2) and the crankshaft balancer alignment mark (4) must align with the engine front cover tab (3).
1. Rotate the crankshaft balancer clockwise until the alignment marks on the crankshaft balancer are aligned with the tabs on the engine front cover
and the number 1 piston is at TDC of the compression stroke.
