Savana 1500 RWD V6-4.3L (2007)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Reluctor Ring Replacement
Crankshaft Position Reluctor Ring Replacement
Tools Required
J 5590 Pinion Bearing Race Installer - Rear
Removal Procedure
1. Remove the engine front cover.
2. Remove the crankshaft position sensor reluctor ring.
Installation Procedure
Notice: Failure to properly align the crankshaft position sensor reluctor ring may result in component damage and effect OBD II system
performance.
Important: The reluctor ring is shaped like a dish. The dish must face towards the engine front cover. Failure to do so will damage the
front cover and the reluctor ring.
1. Install the crankshaft position sensor reluctor ring.
1. Align the keyway on the crankshaft position sensor reluctor ring with the crankshaft balancer key in the crankshaft.
2. Use the J 5590 in order to push the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the
crankshaft sprocket.
2. Install the engine front cover.
