Savana 1500 RWD V6-4.3L (2007)
10. As the distributor is being removed from the engine, watch the rotor move in a counter-clockwise direction about 42 degrees. This will appear as
slightly more than one clock position.
11. Note the position of the rotor segment.
12. Place a second mark on the base of the distributor (2). This will aid in achieving the proper rotor alignment during the distributor installation.
13. Remove the mounting clamp hold-down bolt.
14. Remove the distributor.
Installation Procedure 1
1. If installing a new distributor assembly, place 2 marks on the new distributor housing in the same location as the marks on the original housing.
2. Remove the new distributor cap, if necessary.
3. Align the rotor with the second mark (2).
4. Guide the distributor into the engine.
5. Align the hole in the distributor hold-down base over the mounting hole in the intake manifold.
