Savana 1500 RWD V6-4.3L (2007)
Transmission Speed Sensor: Service and Repair
4L60-E/4L65-E/4L70-E - Automatic Transmission
Vehicle Speed Sensor Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the electrical connector from the speed sensor.
3. Remove the bolt.
4. Remove the speed sensor and the O-ring seal.
5. Inspect the seal and the transmission case. Replace the seal, if necessary.
Installation Procedure
1. Install the speed sensor and the O-ring seal into the transmission.
Notice: Refer to Fastener Notice .
2. Install the bolt.
Tighten the bolt to 11 N.m (97 lb in).
3. Install the electrical connector to the speed sensor.
4. Lower the vehicle.
