Savana 1500 RWD V6-4.3L (2007)
Ignition Lock: Service and Repair
Ignition Lock Cylinder Replacement
IGNITION LOCK CYLINDER REPLACEMENT
REMOVAL PROCEDURE
1. CAUTION: Refer to Battery Disconnect Caution.
Disconnect the battery negative cable.
2. CAUTION: Refer to SIR Caution.
Disable the SIR system. Refer to SIR Disabling and Enabling.
3. Remove the steering column trim covers.
4. Turn the ignition lock cylinder to the start position.
5. Insert the tip of an awl into the access hole (1) of the ignition lock cylinder.
6. Push down and hold the retaining pin of the ignition lock cylinder.
7. Release the ignition lock cylinder to the run position.
8. Remove the ignition lock cylinder by pulling the cylinder away from the steering column.
INSTALLATION PROCEDURE
1. Install the ignition lock cylinder by performing the following procedure:
