Savana 1500 RWD V6-4.3L (2007)
Important: Use new O-ring seals when assembling the power steering pump assembly.
1. Lubricate the O-ring seals (1, 4 and 5) with power steering fluid.
2. To install the control valve assembly and flow control spring to the pump housing assembly (2). Refer to Power Steering Pump Flow Control
Valve Replacement - Off Vehicle .
3. Install the O-ring seals (1, 4 and 5) to the pump housing assembly (2).
4. Install the magnet (3) to the pump housing assembly (2).
5. Connect the reservoir assembly (1) to the pump housing assembly (2).
6. Install the O-ring seal.
7. Install the connector and fitting assembly (4) to the pump housing (1).
Notice: Refer to Fastener Notice .
8. Install the pump mounting studs (2) to the pump housing (1).
Tighten
*
Tighten the pump mounting studs (2) to 58 N.m (43 lb ft).
*
Tighten the connector and fitting assembly (4) to 75 N.m (55 lb ft).
