Savana 1500 RWD V6-4.3L (2007)
*
Accumulator piston (8)
*
Inner ring oil seal (7)
*
Outer ring oil seal (1)
*
Servo piston (2)
*
Bottom retaining clip (3)
*
Cover gasket (4)
*
Cover (5)
*
Cover Bolt (6)
Notice: Refer to Fastener Notice .
2. Install the cover bolts (61).
Tighten the bolts to 24 N.m (18 lb ft).
3. Install the transmission oil pan and filter.
4. Lower the vehicle.
5. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check .
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Transmission Adaptive Functions .
Forward Servo Replacement
Forward Servo Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the oil pan and filter.
3. Remove the six forward servo cover bolts, cover, and gasket.
4. Remove the following parts:
1. Forward servo piston pin (5)
2. O-ring seal (4)
3. Servo piston (3)
4. Retainer (2)
5. Piston spring (1)
Installation Procedure
