Savana 1500 RWD V6-4.3L (2007)
Shift Cable: Service and Repair
4L60-E/4L65-E/4L70-E - Automatic Transmission
Automatic Transmission Range Selector Lever Cable Replacement
Automatic Transmission Range Selector Lever Cable Replacement
Removal Procedure
1. Apply the parking brake.
2. Position the steering column shift lever to park.
3. Remove the knee bolster trim panel.
4. Remove the knee bolster bracket.
5. Remove the clip securing the shift cable to the steering column bracket.
6. Remove the shift cable from the steering column shift control.
7. Pull back the carpet and insulation to gain access to the shift cable pass-through grommet.
8. Remove the rubber grommet from the floor panel.
9. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
10. Remove the shift cable from the stud ball.
11. Remove the locking clip from the cable at the bracket.
12. Unclip the cable from the retainers at the fuel lines and body.
13. Lower the vehicle.
14. Remove the shift cable from the vehicle.
Installation Procedure
