Savana 1500 RWD V6-4.3L (2007)
4. Position the tool J 41364-A onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are
lined up with the lower two tabs on the tool.
Notice: Refer to Fastener Notice .
5. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
Tighten the bolts securing the switch to 25 N.m (18 lb ft).
6. Remove the J 41364-A from the switch. If installing a new switch, remove the positive assurance bracket at this time.
7. Connect the electrical connectors to the switch.
8. Install the transmission control lever to the manual shaft with the nut.
Tighten the control lever nut to 25 N.m (18 lb ft).
9. Lower the vehicle.
10. Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only. If proper operation of the switch can
not be obtained, replace the switch.
