Savana 1500 RWD V6-4.3L (2007)
Notice: Refer to Ring Gear Removal Notice .
9. Remove the ring gear from the differential. Drive the gear off with a brass drift if necessary.
Installation Procedure
Important: The mating surface of the ring gear and the differential case must be clean and free of burrs before installing the ring gear.
1. Install the ring gear to the differential case.
Important: The ring gear bolts have left-hand threads.
2. Install the new ring gear bolts.
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Notice: Refer to Fastener Notice .
3. Tighten the ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
Tighten the ring gear bolts in sequence to 120 N.m (89 lb ft).
4. Install the pinion bearing cups.
5. Determine the selective shim thickness for the pinion gear. Refer to Pinion Depth Adjustment (8.6 Inch Axle) Pinion Depth Adjustment (9.75
Inch, 10.5 Inch Axles) .
6. Install the selective shim onto the pinion.
7. Install the inner pinion bearing to the pinion.
