Savana 1500 RWD V6-4.3L (2007)
1. Install the axle shaft bearing using the J 23690 , 8.6 inch axle, or the J 45853 , 9.75 inch axle (1) and the J 8092 (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
3. For the 8.6 inch axle, install the axle shaft seal using the J 21128 .
Ensure the seal is fully seated in the axle tube.
4. For the 9.75 inch axle, install the axle shaft seal using the J 45853 (2) and the J 8092 (1).
Ensure the seal is fully seated in the axle tube.
5. Install the axle shaft.
6. Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) Rear Axle Lubricant Replacement (9.75 Inch, 10.5 Inch Axles) .
7. Lower the vehicle.
