Savana 1500 RWD V6-4.3L VIN X (2004)
Balance Shaft Bearing: Service and Repair
Balance Shaft Bearing and/or Bushing Replacement
^
Tools Required
-
J 26941 Bushing/Bearing Remover
-
J 33834 Balance Shaft Service Kit
Removal Procedure
Important: The balance shaft and the front bearing are serviced only as a package. Do not remove the bearing from the balance shaft.
1. Remove the balance shaft.
Caution: Refer to Safety Glasses Caution in Service Precautions.
2. Use the J 38834 and the J 26941 in order to remove the balance shaft rear bearing
2.1.
Install J 26941 legs behind the balance shaft rear bearing and Secure.
2.2.
Install the J 38834-1 with the short threaded end through the balance shaft bole in the front of the engine block.
2.3.
Install the J 38834-1 into J 26941
2.4.
Slide the J 38834-2 onto the J 38834-1 an into the balance shaft bore of the engine block.
2.5.
Install the J 38834 bearing, washer, and nut onto the J 38834-1
2.6.
Using a wrench secure the J 38834-1 and then rotate the J 38834 nut clockwise until the balance shaft rear bearing is removed from the
engine block.
2.7.
Remove the J 26941 frown the balance shaft rear bearing.
3. Discard the balance shaft rear bearing.
Installation Procedure
Caution: Refer to Safety Glasses Caution in Service Precautions.
1. Use the J 38834 in order to install the balance shaft rear bearing.
