Savana 1500 RWD V6-4.3L VIN X (2004)
7.3.
Remove the oil cooler hose assembly. Discard the gasket.
7.4.
Inspect the fittings, connectors and cooler hoses for damage or distortion.
Installation Procedure
Important: A distinct snap should be heard when assembling tube ends of the hose assembly to quick connectors. To ensure tube is fully inserted into
the connector, check by giving tube a forceful pull.
1. If equipped with a 6.0L engine. perform the following:
1.1.
Install the oil Cooler hose assembly and new gasket.
Notice: Refer to Fastener Notice in Service Precautions.
1.2.
Install the oil cooler loose adapter bolts (2).
^ Tighten the bolts to 12 Nm (106 inch lbs.).
1.3.
Install the oil cooler hose bracket bolt (1).
^ Tighten the bolt to 25 Nm (18 ft. lbs.).
2. If equipped, install the engine shield.
3. Install the engine shield bolts.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).