Savana 1500 RWD V6-4.3L VIN X (2004)
7. Measure the pan-to-transmission housing clearance using a feeler gage and a straight edge.
Use a feeler gage to check the clearance between the oil pan-to-transmission housing measurement points. If the clearance exceeds 0.3 mm (0.011
inch) at any of the 3 oil pan-to-transmission housing measurement points (1), then repeat the step until the oil pan-to-transmission housing
clearance is within the specification. The oil pan must always be forward of the rear face of the engine block.
Notice: Refer to Fastener Notice in Service Precautions.
8. Tighten the oil pan bolts and nuts in sequence (1-12).
^
Tighten the oil pan bolts to 25 Nm (18 ft. lbs.).
9. Measure the clearance between the 3 oil pan-to-transmission housing measurement points in order to ensure proper alignment.
10. Install a NEW oil pan drain plug seal (O-ring) onto the oil pan drain plug.
11. Install the oil pan drain plug into the oil pan.
^
Tighten the oil pan drain plug to 25 Nm (18 ft. lbs.)
