Savana 1500 RWD V6-4.3L VIN X (2004)
Power Steering Line/Hose: Service and Repair
Power Brake Booster Inlet Hose Replacement
Power Brake Booster Inlet Hose Replacement
Removal Procedure
1. Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the tire and wheel.
5. Remove the power brake booster inlet hose (2) from the power steering pump (1) through the wheelwell.
6. Lower the vehicle.
7. Remove the power brake booster inlet hose (1) from the power brake booster (2).
8. Remove the power brake booster inlet hose from the vehicle.
Installation Procedure
1. Notice; Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
Route the hose in the same position the hose occupied prior to removal.