Savana 1500 RWD V6-4.3L VIN X (2004)
4. Remove the CKP sensor.
INSTALLATION PROCEDURE
IMPORTANT:
-
When installing the CKP sensor, make sure the sensor is fully seated before tightening the mounting bolt. A poorly seated CKP sensor may
perform erratically and may set false DTCs.
-
Do not use the original O-ring.
1. Replace the CKP sensor O-ring.
2. Lubricate the O-ring with clean engine oil before installing the CKP sensor.
IMPORTANT: Make sure the CKP sensor mounting surface is clean and free of burrs.
3. Install the CKP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.