Savana 1500 RWD V6-4.3L VIN X (2004)
2. Apply a few drops of clean engine oil to the male tube ends.
3. Install the fuel feed and return pipes to the injector assembly.
4. Install the fuel pipe retainer and the attaching nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the retaining bolt to the rear fuel pipe bracket.
Tighten
1. Tighten the bracket bolt to 6 N.m (53 lb in).
2. Tighten the retainer nuts to 3 N.m (27 lb in).
3. Install the new O-ring seals on the engine fuel feed and the return pipes.
4. Install the chassis fuel feed and return pipes (3) to the engine compartment fuel feed and return pipes (4).
Tighten
Tighten the fuel pipe nuts to 27 N.m (20 lb ft).
5. Install the retainer nut to the fuel and EVAP pipe.
Tighten
Tighten the retainer nut to 28 N.m (21 lb ft).
6. Tighten the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks:
8.1.
Turn ON the ignition for 2 seconds.
