Savana 1500 RWD V6-4.3L VIN X (2004)
2. Connect the chassis fuel return pipe to the rear fuel return pipe.
3. Connect the fuel feed pipe to the fuel filter.
4. Install the fuel tank.
5. Lower the vehicle.
6. Refill the fuel tank.
7. Tighten the fuel filler cap.
8. Connect the negative battery cable.
9. Inspect for leaks:
9.1.
Turn ON the ignition for 2 seconds.
9.2.
Turn OFF the ignition for 10 seconds.
9.3.
Turn ON the ignition.
9.4.
Inspect for fuel leaks.
10. Install the engine cover.
Filter to Tank (Rear Tank)
FUEL HOSES/PIPES REPLACEMENT - FILTER TO TANK (REAR TANK)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Disconnect the fuel feed pipe the fuel filter.
6. Disconnect the chassis fuel return pipe the rear fuel return pipe.
