Savana 1500 RWD V6-4.3L VIN X (2004)
1. Install the pawl shaft.
2. Install the parking pawl.
3. Install the plug using a 8 mm or (5/16 inch) rod with Loctite or the equivalent.
4. Install the retainer.
5. Install the pawl return spring.
6. Install the detent lever to the actuator assembly.
7. Install actuator assembly over the parking pawl.
8. Install the manual shaft seal.
9. Lubricate the manual shaft with transmission oil and install the manual shaft into the case.
10. Install the nut on the shaft.
11. Install the roll pin.
12. Notice: Refer to Fastener Notice in Service Precautions.
Install the parking lock bracket with the two bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
13. Install the park/neutral position switch.
14. Install the oil pan and filter.
15. Lower the vehicle.
16. Fill the transmission to the proper level with Dexron III transmission fluid.
Park/Neutral Position Switch Replacement
Park/Neutral Position Switch Replacement
^
Tools Required
-
J 41364-A Neutral Position Adjustment Tool
Removal Procedure
1. Apply the parking brake.
2. Shift the transmission into neutral.
3. Raise the vehicle.
4. Remove the nut securing the transmission control lever to the manual shaft.
5. Remove the transmission control lever from the manual shaft.
6. Disconnect the electrical connectors from the switch.
7. Remove the bolts securing the park/neutral position switch to the transmission.
