Savana 1500 RWD V6-4.3L VIN X (2004)
16. Install the manual shaft detent roller and spring assembly (3) and bolts.
17. Install the two wiring harness clips (1) and bolts (2).
18. Install the wiring harness clip (1) and bolts (2).
19. Install the lube oil pipe (5) with the short end into the control valve body.
20. Install the lube oil pipe retainer (7) and the bolt (6).
21. Notice: Refer to Fastener Notice in Service Precautions.
Install the control valve body bolts.
^
Tighten the bolts in the order shown to 11 Nm (97 inch lbs.).
22. Install the remaining control valve body bolts.
^
Tighten the remaining bolts to 11 Nm (97 inch lbs.).
23. Connect the internal wiring harness to the valve body electrical components.
24. Install the oil pan, gasket, and filter.
25. Lower the vehicle.
26. Fill the transmission to the proper level using approved fluid.
27. Fill the transmission to the proper level with Dexron III transmission fluid.
