Savana 1500 RWD V6-4.3L VIN X (2004)
Important: Do not reuse the pinion nut.
5. Install the new pinion nut
6. Install the J8614-01 onto the pinion yoke as shown.
Notice: Refer to Fastener Notice in Service Precautions.
7. Tighten the pinion nut while holding the J8614-01.
Tighten the pinion nut to 339 Nm (250 ft. lbs.).
8. Install the propeller shaft to the rear axle pinion yoke.
9. Inspect and add axle lubricant to the axle housing, if necessary.
10. Lower the vehicle.
