Savana 2500 V6-4.3L VIN X (2005)
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the engine oil pressure gage sensor fitting, if removed. Tighten
1.1.
Tighten the engine oil pressure gage sensor fitting to 15 Nm (11 ft. lbs.).
Important: Do not loosen the sensor fitting. Do not tighten the sensor fitting more than one turn to align.
1.2.
Tighten the sensor fitting until properly align.
2. Install the engine oil pressure gage sensor.
3. Hold the engine oil pressure gage sensor fitting with a wrench to prevent from turning.
^
Using J 41712 tighten the engine oil pressure gage sensor to 30 Nm (22 ft. lbs.).
4. Connect the engine oil pressure gage sensor electrical connector.
5. Install the engine cover.
