Savana 2500 V6-4.3L VIN X (2005)
7. Remove the wheel hub and bearing and splash shield from the steering knuckle.
Installation Procedure
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the wheel hub and bearing and splash shield to the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the wheel hub and bearing mounting bolts.
-
Tighten the bolts to 180 Nm (133 ft. lbs.).
