Savana 2500 V6-4.3L VIN X (2005)
35. Connect the hose from J 38500-A (1) to the service port on the J 44466-12 (3).
36. Open valve (3) at the bottom of J 38500-A.
37. Connect a shop air source to the fitting at the top of J 38500-A and adjust the regulator (1) to 75 psi.
38. Let the vehicle run at idle until the canister is empty and the vehicle stalls.
39. Remove the shop air supply from J 38500-A.
40. Depressurize the J 38500-A.
41. Disconnect the J 38500-A hose from the J 44466-12.
42. Remove the PCV clean air tube from the air inlet duct and set aside.
43. Remove the resonator and air inlet duct from the throttle body and set aside.
44. Remove ignition wires 1, 3, and 5 from the distributor cap.
45. Remove brake booster vacuum hose and connector from the intake manifold.
46. Bleed the residual pressure from J 44466-12.
