Savana 2500 V6-4.3L VIN X (2005)
6. Connect the fuel feed and return pipes (3) to the engine compartment fuel pipes (4).Ensure the O-rings are in place
Tighten the fuel pipe fittings to 27 N.m (20 lb ft) using a backup wrench.
7. Install the fuel pipes to the retainer clip (2).
Tighten the fuel pipe retainer clip nut to 28 N.m (21 lb ft).
8. Tighten the fuel filler cap.
9. Connect the negative battery cable.
10. Inspect for leaks:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
11. Install the engine cover.
Fuel Hose/Pipes Replacement - Chassis (Filter to Tank Cutaway Van Rear Tank)
FUEL HOSE/PIPES REPLACEMENT - CHASSIS (FILTER TO TANK CUTAWAY VAN REAR TANK)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Raise the vehicle. Refer to Vehicle Lifting.
