Savana 2500 V6-4.3L VIN X (2005)
16. Separate the 2 banana plugs on the SIR deployment harness.
17. Place a 12 V minimum/2 A minimum power source, i.e. vehicle battery, near the shorted end of the SIR deployment harness.
18. Connect the SIR deployment harness wires to the power source. Inflator module deployment will occur when contact is made.
19. Disconnect the SIR deployment harness from the power source.
20. Seat 1 banana plug into the other in order to short the deployment harness leads.
CAUTION: Refer to SIR Deployed Inflator Modules Are Hot Caution in Service Precautions.
21. If the inflator module did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group for further
assistance. Otherwise, proceed to the following steps.
22. Put on a pair of shop gloves.
23. Disconnect the pigtail adapter from the inflator module as soon as possible.
24. Dispose of the deployed inflator module through normal refuse channels.
25. Wash hands with a mild soap.
Deployment Inside Vehicle - Vehicle Scrapping Procedures
DEPLOYMENT INSIDE VEHICLE - VEHICLE SCRAPPING PROCEDURES
Deploy the inflator modules inside of the vehicle when destroying the vehicle or when salvaging the vehicle for parts. This includes but is not limited to
the following situations:
-
The vehicle has completed its useful life.
