Savana 2500 V8-4.8L (2008)
Fuel Return Line: Service and Repair
Fuel Hose/Pipes Replacement - Chassis (Cargo/Passenger Van)
Fuel Hose/Pipes Replacement - Chassis (Cargo/Passenger Van)
Removal Procedure
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027) Fuel Pressure Relief (Without CH 48027).
3. Disconnect the fuel feed and evaporative emission (EVAP) pipes from the engine compartment fuel pipes.
4. Disconnect the chassis wiring harness electrical connector (1) from the fuel pressure sensor (2).
5. Remove the chassis wiring harness clip (3) from the fuel pipe.
6. Remove the fuel pipes from the bellhousing stud retainer clip.
7. Raise the vehicle. Refer to Vehicle Lifting.
8. Disconnect the fuel feed pipe at the fuel tank.
9. Disconnect the chassis EVAP pipe from the fuel tank.
10. Remove the fuel pipe retaining clips. Note the location of the retaining clips for installation.
11. Remove the fuel feed and EVAP pipes.
Installation Procedure
