Savana 2500 V8-6.0L VIN U (2006)
6. Remove the connector position assurance (CPA) from the front end sensor connector located on the frame crossmember.
7. Disconnect the front end sensor connector.
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the front end sensor connector to the front end sensor.
3. Install the CPA to the front end sensor connector.
4. Install the SIR fuse into the fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Vehicle, if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 3
SIR DISABLING AND ENABLING ZONE 3
DISABLING PROCEDURE
1. Turn the steering wheel until the vehicles wheels are pointing straight ahead.
IMPORTANT: Refer to SIR Service Precautions before disabling the SIR system.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
4. Remove the SIR fuse from the fuse block.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate
an SIR system malfunction.
5. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering
column near the knee bolster.
6. Disconnect the steering wheel module yellow 4-way connector (2).
ENABLING PROCEDURE
1. Remove the key from the ignition.
