gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

SIR Disabling and Enabling Zones|Page 14586 > < SIR Disabling and Enabling Zones|Page 14584
Page 4
background image

1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.

7. Perform the Diagnostic System Check - Vehicle, if the AIR BAG indicator does not operate as described.

SIR Disabling and Enabling Zone 7

SIR DISABLING AND ENABLING ZONE 7

DISABLING PROCEDURE

1. Turn the steering wheel until the vehicles wheels are pointing straight ahead.

IMPORTANT:  Refer to SIR Service Precautions before disabling the SIR System.

2. Turn OFF the ignition.
3. Remove the key from the ignition.
4. Remove the SIR fuse from the fuse block.

IMPORTANT:  With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate
an SIR System malfunction.

5. Remove the connector position assurance (CPA) (1) from the steering wheel module yellow 4-way connector (2) located left of the steering

column near the knee bolster.

6. Disconnect the steering wheel module yellow 4-way connector (2).

7. Remove the CPA from the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.
8. Disconnect the LF seat belt pretensioner yellow 2-way connector (1) located under the driver seat.

9. Remove the right knee bolster bracket. 

10. Remove the CPA from the I/P module yellow 4-way connector (1) located behind the I/P support.
11. Disconnect the I/P module yellow 4-way connector (1).

SIR Disabling and Enabling Zones|Page 14586 > < SIR Disabling and Enabling Zones|Page 14584