Savana 2500 V8-6.0L VIN U (2006)
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Tighten the ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
Tighten the ring gear bolts in sequence to 120 Nm (89 ft. lbs.).
4. Install the pinion bearing cups.
5. Determine the selective shim thickness for the pinion gear.
6. Install the selective shim onto the pinion.
7. Install the inner pinion bearing to the pinion.
8. Install a new collapsible spacer.
9. Lubricate the pinion bearings with axle lubricant.
10. Install the outer pinion bearing into the axle housing.
11. Install the new pinion oil seal.
12. Install the pinion into the axle housing.
13. Install the pinion yoke.
14. Install the differential assembly.
15. Fill the axle with lubricant. Use the proper fluid.
16. Lower the vehicle.
