Savana 2500 V8-6.0L VIN U (2006)
11. Install the propeller shaft (3) to the rear axle pinion yoke (4). Align the shaft and the yoke using the marks made during removal.
Notice: Refer to Fastener Notice in Service Precautions.
12. Install the yoke retainers (2) and the bolts (1).
Tighten the rear axle pinion yoke retainer bolts to 25 Nm (18 ft. lbs.).
13. Using the J43218 or equivalent, crimp the outer tube clamp.
14. Adjust the boot (4) length so that it is 124 - 134 mm (4.88 - 5.28 inch) from end to end.
15. Using the J43218 or equivalent, crimp the rear inner tube side clamp.
16. Lower the vehicle.
