Savana 2500 V8-6.0L VIN U (2006)
Wiper Motor: Service and Repair
Wiper Motor Cover Replacement
WIPER MOTOR COVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the wiper motor.
4. Remove the 3 screws (2) and the wiper motor cover (3) from the wiper motor (1).
5. Remove the wiper motor cover (3).
INSTALLATION PROCEDURE
1. Install the wiper motor cover onto the wiper motor with the 3 screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 3 N.m (26 lb in).
2. Connect the electrical connector to the wiper motor.
3. Install the air inlet grille panel.
4. Install the wiper arms.
5. Operate the wipers and inspect for proper operation.
