Savana 2500 V8-6.6L DSL Turbo (2008)
Trim Panel: Service and Repair
Body Side Front Garnish Molding Replacement - Left Side
Body Side Front Garnish Molding Replacement - Left Side
Removal Procedure
1. Open cover and remove screw, if equipped with roof rail inflatable restraints.
2. Pull out on the center pillar garnish (1,2) molding to disengage the clips.
3. Remove the center pillar garnish molding.
Installation Procedure
1. Align the body side upper (1,2) garnish molding clips to the holes in the body.
2. Push in on the body side upper (1,2) garnish molding to engage the clips.
Notice: Refer to Fastener Notice.
3. Install screw and close cover, if equipped with roof rail inflatable restraints.
Tighten the screws to 2 N.m(18 lb in).
