Savana 2500 V8-6.6L DSL Turbo (2008)
6. Remove and discard the oil fill tube O-ring seal.
Installation Procedure
1. Install a NEW O-ring seal onto the oil fill tube.
2. Install the oil fill tube.
Notice: Refer to Fastener Notice .
3. Install the lower oil fill tube bolt (1).
Tighten the bolts to 21 N.m (15 lb ft).
4. Install the starter. Refer to Starter Motor Replacement (4.3L) Starter Motor Replacement (4.8L, 5.3L, and 6.0L) Starter Motor Replacement
(6.6L) .
5. Install the upper oil fill tube bolt (1).
