Savana 2500 V8-6.6L DSL Turbo (2008)
Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Remove the lower oil pan. Refer to Lower Oil Pan Replacement (See: Oil Pan/Service and Repair/Lower Oil Pan Replacement) .
2. Remove the oil level sensor clip (3).
3. Remove the oil level sensor bolt (2) and sensor (1).
Installation Procedure
Important: When routing the oil level sensor wire, ensure that the wire is routed along the side of the oil pan.
1. Install the oil level sensor (1) and bolt (2).
Tighten the bolt to 9 N.m (80 lb in).
2. Install the oil level sensor clip (3).
3. Install the lower oil pan. Refer to Lower Oil Pan Replacement (See: Oil Pan/Service and Repair/Lower Oil Pan Replacement) .