Savana 2500 V8-6.6L DSL Turbo (2008)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Rear Oil Seal Replacement
Tools Required
*
J 44641 Crankshaft Rear Oil Seal Remover
*
J 44642 Crankshaft Rear Oil Seal Installer
Removal Procedure
1. Remove the engine flywheel. Refer to Engine Flywheel Replacement (See: Transmission and Drivetrain/Flex Plate/Service and Repair/Engine
Flexplate/Flywheel Replacement)
2. Install the J 44641 to the crankshaft rear oil seal.
3. Remove the crankshaft rear oil seal using the J 44641 .
Installation Procedure
1. Place the crankshaft rear oil seal onto the crankshaft.
Important: The J 44642 must be fully secured to the crankshaft to ensure proper seal depth.
2. Install the J 44642 to the crankshaft.
3. Press the crankshaft rear oil seal into position using the J 44642 . The J 44642 will bottom out when the seal reaches the proper depth.
4. Remove the J 44642 .
5. Install the engine flywheel. Refer to Engine Flywheel Replacement (See: Transmission and Drivetrain/Flex Plate/Service and Repair/Engine
Flexplate/Flywheel Replacement) .