Savana 2500 V8-6.6L DSL Turbo (2008)
Shift Cable: Service and Repair
4L80-E/4L85-E - Automatic Transmission
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
1. Apply the parking brake.
2. Position the steering column shift lever to park.
3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Replacement .
4. Remove the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
5. Remove the clip securing the shift cable to the steering column bracket.
6. Remove the shift cable from the steering column shift control.
7. Remove the rubber grommet from the floor panel.
8. Remove the air cleaner assembly.
9. Remove the shift cable clips from the left front of the engine compartment.
10. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
11. Remove the shift cable clips from the left rear engine bracket.
12. Remove the shift cable from the stud ball.
13. Remove the locking clip from the cable at the bracket.
14. Lower the vehicle.
15. Remove the shift cable from the vehicle.
